ROAMiQ Hub · Getting started

Two connections. Then you’re ready.

Connect your Hub to your router with Ethernet, then choose one of three supported ways to power it. That’s all it takes to complete the initial connection.

Ethernet cable Open router LAN port One power source
1

Network first

Connect the Hub to your router

Plug one end of an Ethernet cable into an open LAN port on your router. Plug the other end into the Ethernet port on the ROAMiQ Hub. Press each connector in until it clicks into place.

Keep the router powered on. The Ethernet cable gives the Hub its network connection. Use one of the power inputs below to supply power.

2

Choose one

Power the Hub your way

Your installation only needs one power connection. Use the input that best matches your setup.

Simple bench setup

USB-C

Minimum: 5 V / 5 A

Use a 27 W USB-C PD supply and a 5 A-rated cable.

Screw terminal

7–36 V DC

Minimum: 36 W

Use 12 V / 3 A or 24 V / 1.5 A. Match + and − before powering on.

Barrel jack

12 V DC

Minimum: 12 V / 3 A

Use a regulated DC supply with the correct plug and polarity.

Connect only one power input at a time. Before wiring the screw terminal, disconnect power and verify both voltage and polarity.

Ready check

One cable. One power source.

  • The Ethernet cable is firmly seated at both ends.
  • One supported power source is connected.
  • The router and its LAN connection are powered.
Continue to step 2Open your ROAMiQ dashboard