Integration Modules
Wiring and installation guides for every ROAMiQ control chip — one page for all of them.
Integration module wiring
MaxxFan LinkROAMiQ MaxxFan Control Chip: wiring and installation guideWire the ROAMiQ MaxxFan Control Chip between the fan and 12V supply, connect the RJ45 cable, and place the chip neatly inside the fan housing.Read guide →RV-C LinkROAMiQ Espar Control Chip: wiring and installation guideConnect the ROAMiQ Espar Control Chip directly to an Airtronic or Hydronic harness, match four wire colors, remove the terminator, and disconnect EasyStart Pro.Read guide →Bluetti LinkROAMiQ BLUETTI Control Chip: wiring and installation guideConnect your ROAMiQ Chip to a BLUETTI EPAD through the RV-C Expand Bus port and enable RV-C communication on firmware V300450112.Read guide →EcoFlow LinkROAMiQ EcoFlow Control Chip: connect to the EcoFlow Power LinkPlug the ROAMiQ EcoFlow Control Chip into the Power Link's CAN port with the included cable, set both protocol switches OFF, and power the chip over USB-C.Read guide →12V Motor RelayROAMiQ 12V Motor Relay V2: wiring guide and FAQWiring for the ROAMiQ 12V Motor Relay V2: power, motor and a momentary rocker switch into the three lever terminal blocks, plus the active-low switch inputs, soft start/stop and built-in jam, stall and timeout protection.Read guide →12V Motor RelayROAMiQ 12V Motor Relay: wiring guide and FAQStep-by-step wiring for the ROAMiQ 12V Motor Relay — match each labeled harness wire to its terminal, wire an active-low momentary switch, and understand the built-in stall/overcurrent protection.Read guide →12V Motor RelayROAMiQ Dual Channel Relay: Happijac bed lift wiring guideWire the ROAMiQ Dual Channel Relay (RQ-MCM) into a Happijac bed lift control box. The relays stand in for the UP and DOWN switch contacts, the wall switch moves to the ground-triggered inputs, and the bed runs from the switch or the ROAMiQ app.Read guide →12V DC DimmerROAMiQ 12V DC Dimmer: wiring guide and FAQWiring for the ROAMiQ 12V DC Dimmer: power, light and wall switch on the 6-position terminal, choosing the Switch Mode, and the built-in overcurrent protection.Read guide →
Can't find your device? Contact us and we'll help.